Feature

●Warm Up Quick: This 858D microcomputer controlled soldering station quickly heats up to the set temperature within 3-5 seconds. The highest temperature is 500 ° C.
●Digital LED Display: Unique Rework Station With digital LED display, high performance, temperature stabilization and airtightness. Use the brushless fan, long life and low noise.
●Automatic Cooling Function: can effectively extend the life of the heater and protect the heat gun. This is safer for the user. It also has a memory temperature function: Turn off the 858D rework station at a certain temperature. If you turn it on, it will quickly heat up temperature.
●Accurate Temperature Control: Remove BGA IC safely, keep pins intact. Much safer and more reliable. Blowing PCB will not blow it
●Much safer and more reliable. Blowing PCB will not blow it off Indispensable product for repairing mobile phones, laptops, PCBs, etc. Suitable for soldering multiple components such as SOIC CHIP QFP PLCC and BGA etc. (especially for flat cables and cable connectors).

Description

Our products 858D use the brush-less fan,and long life and low noise.It is very good for shielding box and PCB.Please read this operating instruction manual carefully before using the serial products of our company.Thank you!

Specification:

Power Voltage: 110V

Plug type: US

Power consumption:700W

Blower fan: Brushless Fan

Amount of Wind:120L/m(MAX)

Temperature Range:100℃-500℃

Discharge Feature：LED indicator light

Handle Length :120cm

Noises :<45db

Weight:1.8KG/3.97LB

Operation Instruction

1. To put unsoldering equipment ready, and take off the handle from the holder.

2. To turn on the power.

3. To set the best nozzle(large caliber nozzle preferred)

4. To switch on the power, the screen displays”----”, it represents standby mode.

5. To press ↑ or ↓ button(revolving switch) to set up the temperature.

6. To turn the airflow power adjusted switch to set up the required wind speed.

7. To hold the handle, so the equipment begins to heat. To adjust the revolving switch of airflow in order to select suitable airflow, and the station can be operated normally while the temperature is stable.

8. Please put the handle back on the holder when you stop working; meanwhile, the heat gun handle will cool down automatically.

While the temperature is lower than 100℃, the screen displays “----”, it stands for switching to standby mode, and after the temperature of Heating element is less than 70℃, the equipment is on standby(If there is airflow out, it means the temperature is higher than 70℃; and there is no airflow only after the temperature is lower than 70℃).

9. To turn off the power and unplug if there is no operation for a long period of time.

Hot air gun connector

Note: The correct insert way is groove upward.

1,2 :hole-sensor

3 hole: magnet switch

4 hole: ground lead

5,6 hole: heat gun

7,8 hole: heating stuff

Jacks need to be one-to-one to avoid grounding failure

Hot air gun

Strong power brush-less fan, stable wind supply Unique designed to, prevent hot air return

Cautions: Try to set up the temperature as lower as possible and the airflow as much as possible as to keep the heating element working longer and protect IC chips.


HSS heat gun nozzles	replaced plug	HSS nozzle

Hot air gun connector

Hot air gun

HSS heat gun nozzles

replaced plug

HSS nozzle

Product guides and documents