PanaVise is a major manufacture of Vises and Work Holding Tools. PanaVises Tilt, Turn & Rotate technology has been applied to the product line, allowing for maximum efficiency and many different uses. Introducing the Panavise 318-14 14-Inch CROSSBAR for 315, 324 and 333, Add longer cross bars for wider circuit boards! Working on bigger boards? Extend the width of any PanaVise Circuit Board Holder with our Cross Bars! For use with the 315 Circuit Board Holder, 333 Rapid Assembly Circuit Board Holder, and 324 Electronic Work Center. When selecting a crossbar, add a minimum of 2-Inch (50.8mm) to your widest circuit board width to accommodate Circuit Board Arms.
The PanaVise 318-14 14" crossbar is a replacement accessory for PanaVise circuit board and electronics work-holding tools, including the 315 circuit board holder head, the 324 electronic work center, and the 333 rapid assembly circuit board holder. The 318-14 14" crossbar replaces any existing crossbars on these tools, and is compatible with all PanaVise circuit board holder arms which attach to its length, allowing for single circuit boards up to 12" wide to be securely held. (A minimum of 1" of cross bar length is required to support each circuit board holder arm) Alternately, multiple pairs of PanaVise circuit board holder arms can be attached to the 12" of usable space on the 318-14 14" crossbar to allow multiple smaller circuit boards to be mounted simultaneously.
All PanaVise products are warranted against defective materials and/or workmanship to all original consumer owners from the date of original consumer purchase for the lifetime of ownership by the original consumer owner. In the event of defective materials and/or workmanship, PanaVise Products, Inc. will, without charge, repair or replace, at its option, the defective product within 60-days from the receipt of the defective product. The Warranty does not apply to damage not resulting from defective materials and/or workmanship while in the possession of the original consumer or to unreasonable use by the original consumer, which includes but is not limited to improper installation, or failure to provide reasonable and necessary maintenance.
Founded in 1957 by tool and die maker Otto Colbert and currently headquartered in Reno, Nevada, PanaVise is a leader in work-holding products. Over the years, a natural outgrowth of this expertise has been continued development of other items which hold things securely and offer a wide range of motion. Important areas in which this has been applied include, electronics, CCTV camera mounts, and audio/video mounts, earning PanaVise the nickname the "the hold it anywhere you want it company."