[Green Gear Indicator]
[Blue Gear Indicator]
[Red Gear Indicator]
Instructions Guide:
You need to connect 4 wires to the bike?s wiring harness. Good quality quick connectors are supplied (4 pcs wire taps). No need to cut any wires and no need for soldering.
All connections can be done either under the fuel tank, at the ECU box or behind the instrument cluster.
The table below shows the connection overview:
GFYSHIP wire
Red Connect to +12V switched power lead
Black Connect to Ground lead or chassis ground
White Speed Signal, tap anywhere between the Speed Sensor and instrument cluster.
On some ABS models, tap the speed signal anywhere between the ABS computer and ECU box.
Green Connect to Tacho signal, tap anywhere between the ECU box and instrument cluster.
Alternatively, tap the signal wire from the 2-wire
Crankshaft Sensor (Pickup coil), anywhere between the sensor and ECU box.
To complete the install, it is recommended that you consult with your dealer and/or refer to the Service Manual available for your bike.
Due to the large number of bike models and vehicles compatible with this Kit, model specific wire colors and install instructions are not described in this document.
1. The ignition key should be in OFF position. Remove the seat, raise and support the fuel tank
2. Locate the Speed Sensor coupler.
A. Most motorcycles have the speed sensor mounted on the gearbox. Others have the sensor mounted either at the front or at the rear wheel.
B. Trace the cable until you find the speed sensor coupler. It is a 3-pole connector.
C. If in doubt, check the bike?s Service Manual or ask your dealer for the location of the Speed Sensor coupler.
Fitment:
For Suzuki VL1500 Intruder 1998-2004
For Suzuki LT-A700X KingQuad ATV 2005-2007
For Suzuki LT-A750X KingQuad ATV 2008-2015
For Suzuki LT-A750XP KingQuad ATV 2009-2015