Specification:
Condition: 100% Brand New
Item Type: Dent Puller
Material: Zinc Alloy
Size (As Shown in Picture): Approx. 3.5cm / 1.4in, 3cm / 1.2in, 2.5cm / 1.0in, 2.2cm / 0.9in, 2.7cm / 1.1in, 3cm / 1.2in, 2cm / 0.8in, 3.2 x 1.6 cm / 1.3 x 0.6 in
Weight: Approx. 120g / 4.2oz
How to Use This Paintless Dent Repair Kit?
1. Clean the dent with a clean wet cloth;
2. Mount the glue stick into the glue , pull the trigger to let the glue stick enter into the glue , connect the power source and preheat for 5 minutes;
3. Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is);
4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);
6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
7. Check with a line board. If dent still exists, knock it slightly with a flattening hammer or pen;
8. Clean the repaired place with a clean wet cloth.
Package List:
8 x Dent Puller
Note:
It is necessary to cooperate with the hammer, glue and glue stick to be used normally.