Plastic Water Flow Switch G1/4 Thread Water Sensor Normally Open Water Switch Fits for Water Dispenser Water Purifier water purifier G1/4" Liquid Water Flow Sensor Flowmeter Water Flow Switch Suitable for Water Dispenser Purifier
Features:
When the water flows in the preset- flow channel, it pushes the magnet- to displace. When it moves to the corresponding reed- tube, the reed- tube conducts after sensing the magnetic field. When there is no water flow, the magnet- returns to its position under the thrust of the spring, and the reed- tube is disconnected after the corresponding reed- tube cannot the magnetic field.
Thread: G1/4-inch, flow: 300ml/min-, response time: less than 1s.
Lightweight, reasonable size, stable performance, low water pressure start-, easy to install, safe to use.
Can be perfectly used for water dispenser, water purifier, water vending machine, etc
material, which is sturdy- and durable in use.
Specifications:
Material: Plastic
Applicable water quality: turbidity less than 1; Fe-, C-o & Ni- less than 0.3Mg-/L
Applicable water pressure: equal or less than 0.8mpa
Applicable water temperature: 5~50℃
humidity: less than 85%
Storage temperature: -20~50℃
Thread: G1/4
flow: 300ml/min-
Response time: less than 1s
Switch type: Normally open
Length of wire: 50cm
Cable- connection strength (outlet end of the body) : Exert 20N-10s tensile force along the of the
Apply 20N-10s pulling force along the vertical direction of the (no damage at the connection)
Hydrostatic pressure: Open 1.05MPa for 5 minutes (no leakage or damage
Voltage-resistance: applied between live- part and non-live- part
DC160V, 1min or DC200V, 1s
(No flicker or breakdown
closing current: 0.5A
load current :1A
On resistance :0.12Q-
Disconnect-resistance :10120
Power connection c