Feature

●High performance MCU,which with 8-bit C8051 core and working frequency up to 50Mhz;High cost performance of ESC,elaborate circuit design and strong anti-interference;Support brushless motor up to 24ok erpm.
●Thre starting mode can be set,throttle response fast,and the speed regulation linearity is very stable,which is suitable for various RC boat;Multipe protection make the equiqments safety.beeping alarm can indicate working condition.
●Good safety performance when power on,when power on,the motor will not be started inmmediately regardless of the throttle position of the remote controller;Built in 5A switch BEC,it can carry the steering gear with high load power.
●ESC can work in water for a short time(Note:if there is water after,please dry the water before use.) ;Cycle programming menu for easy operation .Compitable with all kinds of remote controlpragramming.
●Support programming via programming card (extra Programming Card needed);Water cooled aluminum heat sink effectively slow dowm the temperature rise;Low voltage protection threshold can be set to meet personalized needs.


Description

Five Protection Function：

  • Power on safety protection:if the throttle is not the neutral position after power on,the motor will emit alarm,the motor will emit alarm.The motor can not be started until the netural position throttle is detected.
  • Low voltage protection:if the voltage is lower than the set set low-voltage protection threshold,ESC will automatically reduce the output power for protection. After running for several seconds,the motor will stops,it can restart when the throttle returned to neutral position.The above operation can be repeated.
  • Start-up protection:ESC will cut off output if it fails to start the motor within 3 seconds by accelerating throttle.you need to move the throttle back to the neutral position and restart the motor.(The possible causes:Bad connection or disconnection between ESC&motor,propellers are blocked,etc)
  • Over heat protection:When ESC temperature is high than 100℃,it will reduce output power(throttle will be limited below 40%)for protection,make the motor has enough power for return,when the temperature drops to 80℃,ESC will return to normal working.
  • Throttle signal loss protection:ESC detects the loss of throttle signal during motor running,it will cut off output immediately to avoid an even greater loss caused by the continuous high speed rotation of motor.ESC will return the corresponding output after the signal is restored.

Troubles Shooting:

  • Why after power on,the motor doesnt work and doesnt emit any sound ?

1、Clean the connector or replace them,check and confirm that the polarity is correct;Solder the wire again;Check battery voltage,use full-charged battery;Clean up and dry the water of ESC,try again;replace ESC.

  • Why after power on,ESC works ,but the motor doesnt work and doesnt emit any sound?

Check the connectors or replace the connectors or solder the motor wire again;Change motor.

  • Why after power on, ESC emits the sound of battery cells, but motor doesnt work?

Calibrate throttle range again.

  • Why After power on , the motor doesnt run and emits warning tone“B-B- ,B-B-,B-B-”.(emits Battery voltage out of range every 1.5 seconds)?

Check the battery voltage is within the range of ESC.

Whats in the box

  • 150A ESC*1