Feature
●???????????? ????????????: Bat exclusion tool is made of polyethylene material, it’s light weight but tough enough, can be reused for many times. It can help you disperse bats from the building, will not damage the surface of your structures and protect your architectural beauty.
●???????????????????? ?????? ??????????????????: Bat remove plastic cone device is a simple and efficient bat removal tools, can be used in a variety of buildings. The installation of media compatibility is wide. can be used such as U-shaped nails, tape, silica gel and other materials for fixation. The narrower openings prevent bats from re-entering the structures.
●???????????????????????? ????????????????????: This product can be used to help any structures bat eviction. In order to obtain the best use effect, it is recommended that the installation angle is inclined downward, preferably more than 60 degrees, so that bats can leave through the cone device out of the structure as soon as possible.
●???????? ?????? ????????????: 5.8 x 3.2 inches, wights 30g. If the hole is bigger than the cone device, you can install multiple side-by-side for use. Just refer to the instructions for detailed steps to install, you can avoid bat harassment, regain control of the building.
●?????????? ???????? ??????????????: Please Feel Free to contact us with any questions. Note: Do not remove bats during their birth cycle, as this may cause their babies to be forced to stay in the building.
[4 Pack]
[2 Pack]
[1 Pack]
Description
Installation suggestions: 1.Before installation, Please confirm the location of the bats in the structure, and observe at dusk or dawn to confirm the best point for the bats to enter and exit the structure. Tips: ① Confirm the number of bats. If there are more than 20 bats, it is recommended to install multiple cone equipment to obtain the best effect. ② If the opening in and out of the structure is larger than the cone device opening, multiple cones can be installed side by side for use. 2. Beat other inactive areas in advance to prevent bats from entering other areas. Use copper wire mesh, poly foam, silicone or foam pad to close other opening areas. Make sure that bats stay in one area to ensure that all bats can be totally removed. 3. Use 3/8 U-nails, 1 "screws or silica gel to fix the conical base on the opening that bats use to stay inside the structure. Install at a downward angle, preferably greater than 45 degrees, to achieve the best use effect. 4. Possible Tools: tin snips, scissors or razor knife to trim to fit variant applications. 5. Please leave the installed devices in place for at least 3-5 days to ensure that the bats completely leaves the structure. Once it is confirmed that bats have completely left, the cone can be removed and the opening should be sealed to prevent bats come back to your structure again.