PUMP ONLY! DOES NOT INCLUDE MOTOR/ENGINE! FLUX 430 10 410 Drum Pump, Higher Head, Type F 430 AL-41/37 Z, 39" Long Tube in Aluminum Alloy AlMg5, ETFE Impeller, Shaft in 316 Ti Stanless Steel, O-Rings and Seal in NBR. Maximum Temp 212 F. Tube Outer diameter 1-19/32" (41mm)". Mechanical Seal in Ceramic Oxide, PTFE/Carbon. Outlet connection is BSP 1 1/4" male. Select this FLUX Pump if the pump must be used with many varying liquids, and consequently the smallest residual left within the pump is unacceptable. You want to pump adhesive substances like paints or liquids which tend to crystallize or harden. The pumps inner tube of the pump houses the shaft. It is sealed at the bottom by a mechanical seal through which the shaft passes. Due to this feature the shaft does not come into contact with the liquid except for the small section between the impeller and seal. When using the pump with a discharge hose (of approximately 6,5 ft) and a hand nozzle, the delivery rate will be approximately 18 GPM. Depending on the motor type a 55 GAL drum can be emptied within 3. 4 minutes. The delivery rates shown in the performance charts are obtained at the outlet connection of the pump. FLUX drum pumps in aluminium alloy AlMg5 are suitable for transferring neutral liquids. Special advantages: The shaft support bearings are isolated from the liquid; Extended service life through well proven seal design. Tube Set ONLY! NO MOTOR OR HOSE INCLUDED.