How to Use the Bridge Dent Puller?
1. Insert the glue stick into the 100W glue gun, then heat it for about 2-5 minutes until the glue spill out from the glue gun.
2. Choose a tab and apply hot melt glue on it. There are 8 black tabs for the bridge dent puller, and you can choose it according to the dent size.
3. Put the tab on the dent, hold on and wait for a minute until the hot melt glue is a clod.
4. Use the bridge dent puller to align, then tighten the screw slowly with proper power until the surface of the dent is flatted or sightly bulged. The process should proceed carefully and slowly.
5. Spray 75% rubbing alcohol all over the residual glue, wait for 1-3 minutes. Peel it off or remove it with a plastic shove.
How to Use the Gold Dent Lifter?
1. Insert the glue stick into the 100W glue gun, then heat it for about 2-5 minutes until the glue spill out from the glue gun.
2. Choose an appropriate tab and apply hot melt glue to it. 50 tabs can be used.
3. Put the tab on the dent, hold on and wait for a minute until the hot melt glue is a clod.
4. use a dent lifter and adjust its height to repair dents.