Dry Film, 95 percent pure metallic zinc. Rust and corrosion inhibited. Designed for: coating and covering metal services with a thin film of 95 percent pure zinc, to eliminate surface corrosion caused by welding and assemblies where the coating has been damaged. Recommended lubrication: agitation needed to mix the product. Shake the can for two minutes prior to spraying. Hold the can 12" from the surface, allowing the cone spray pattern to dispense evenly over the parts. The zinc will quickly dry on contact leaving behind a grey thin film. Not recommended for: oxygen service. Appearance; grey. Personal precautions: wear gloves and protective overalls. Environmental precautions: do not allow it to enter drains. Spillage: scrape up bulk, then wipe up remainder with cloth. To prevent walking hazard, pick up remaining residue with diatomaceous earth. Handling: no special handling precautions necessary. Storage: protect from sunlight, dont expose to temperatures exceeding 122 degree F (50 degree C). Do not puncture or burn, even after use. Keep away from sources of ignition and out of children’s reach. Main hazards-health effects: eyes: may cause irritation. Inhalation: may cause dizziness, irritation of nasal passages and eyes in high vapor concentration. Ingestion: may cause diarrhea. Skin: for hypersensitive persons, may irritate the skin after prolonged periods of contact. Respiratory protection: none needed in well ventilated areas. Hand protection: protective gloves for hypersensitive persons. Eye protection: glasses, if applied to parts in motion. Body protection: chemical resistant apron. Size: 14.75 ounces aerosol. Eco-certified.