-Be suitable for all kinds of water level sensors with same signal, and display liquid level of the water tank
-Use moving-magnet principle to drive the needle, featuring good endurance and anti-vibration.
-IP67 waterproof and dustproof grade
-Stepper motors used for full range of stepping gauges, great feature with its less power consumption, longer life, higher precision, etc.
-With curved glass (with anti-fogging function)
-With ultra-wide working voltage design( long-term operating voltage: 9-32V, Maximum up to: 36V (≤ 1 min)).
|
|
|
---|---|---|
How to install it?- Cut an 52mm (2 1/16") hole in the panel and allow a clearance of 70mm (2 3/4”) behind the panel to fit the gauge. - Put the gauge in the hole. - Using M4 nut and C type bracket to seal up the gauge. |
How to connect wires?Red wire --- Power Positive. Black wire --- Water Level Signal. Orange wire (backlight) --- Power Positive. Blue wire --- Power Negative. Please note: Water level meter can be connected to 12VDC and 24VDC power directly. |
Why does water level meter not work?- Water level meter cannot work well. Because its signal dont match the signal of water level sensor. - Confirm your water level meter signal firstly. - If its signal is 0-190 ohm. please work properly with water level sensor 0-190 ohm. - If its signal is 240-33 ohm. please work properly with water level sensor 240-33 ohm. |
Fixing dimension | 52mm(2") |
Indicating Range | E-1/2-FULL |
Signal | 240-33ohm |
Working Voltage | 9-32V(12V/24V) |
Backlight | Red |
Operation mode | LCD display, stepper motor |
NO. B075C87C23 (White+Stainless Steel)
NO. (Black+Stainless Steel)
NO. B075C7J7X5 (Black+Black)
1x Water Level Gauge
1x Multi-plug socket
1x Installation Instruction