Feature
●1. The push rod cannot work continuously for a long time. The operating frequency of the push rod is 10%-20%. If there is a short-term continuous use, the maximum number of times of expansion and contraction in a day cannot exceed 200 times
●2. The push rod has a built-in limit switch. End to end (extend to the end and retract to the end) automatically stop, and stop when any power is cut off in the middle, the push rod is controlled by the positive and negative pole exchange (the positive and negative pole push rod extends, otherwise the push rod retracts). The two wires have no distinction of positive and negative poles. If there is no response after connecting, please connect them in reverse.
●3. The stroke of the push rod is not adjustable. It has been set at the factory, and the internal limit switch is welded up. If you want to adjust it, disassemble the push rod and re-weld the limit switch, which is more troublesome. This operation is not recommended.
●4. After the putter speed is selected, the putter speed can only be adjusted by adjusting the voltage. At this time, reduce the voltage and reduce the speed.
[White]
Description
Specification
Voltage range: DC6V-24V
Working current: rated 5A peak 10A
Duty Cycle (PWM): 0%-100% LED digital tube visual display
Frequency: 13Khz
Remote control distance: up to 100 meters in an open environment. Need to pull out the remote control antenna and adjust the receiving motherboard antenna.
Power supply wiring mode: V+ connects to the positive pole of the DC input, V- connects to the negative pole of the DC input or use the DC 5521 socket to input.
Motor wiring mode: M+ connects to the positive pole of the motor, M- connects to the negative pole of the motor.
Remote control pairing method:
1. Press and hold the motherboard pairing button for 2 seconds and then let go. At this time, the pairing indicator will be on, and then press any button on the remote control. When the pairing indicator is off, the pairing will be successful. If it fails, please try again and again.
2. Long press for about 10 seconds, after letting go, the pairing LED flashes quickly for 2 seconds to clear all previous pairings.
Notice
This governor does not have reverse connection protection. Reverse connection will burn the main board. Please confirm the positive and negative poles and voltage range before turning on the power.